Press or The hour display will start blinking. If you are programming the controller for the first time, the word OFF will blink on the display.
Press will appear opposite the word 'Days'.Press and or until the minute digits reach 10 Press on (±) or 8 to change the watering duration as in the example.Press until appears opposite "Duration".m., for IO minutes each time, on Tuesday and Friday. Let's assume that we want to program the irrigation controller to water three times a day, at 8: 00 a.
Programming a Weekly Irrigation Schedule (Set Days of the Week) If the last parameter stops blinking before you have completed your programming, press S to continue the process.
* Display digits will stop blinking after IO seconds. Set the drop on the current day of the week by pressing on and.Press until a blinking drop appears at the top of the display.Pressmg these buttons again will revert the display back to AM/ PM. For a military clock display, press concurrently on and buttons once the hour digits stop blinking. Set the current minute with the aid of and. Set the current hour with the aid of and ). To enable the irrigation controller to operate the irrigation system at the required times, the current time and day of the week must be set as shown below: After IO minutes, the controller will implement 5- minute irrigation on a 24- hour cycle. * If no changes are implemented, the controller display will always revert to the main screen (clock).Įmergency Irrigation: If no buttons are pressed, the clock will blink continuously. adds on an hour).ĭata decrement (decrease)- lowers the value of the selected parameter (e. To implement the change, the selected parameter must be blinking.ĭata increment (increase) - raises the value of the selected parameter (e.g. Parameter selection - used to select the parameter to be changed (e. Programming step - used to select the appropriate programming mode (e.g. The Computerized Irrigation Controller is programmed with the aid of 4 buttons: Simply alter data in the examples to adapt the program to meet your irrigation requirements. This section contains examples of weekly and cyclical irrigation programs. Removing batteries from the top end may damage the connectors. If necessary, use the flat end of a small screwdriver. Lift the lower end of the battery (2) first.Remove the battery compartment cover (1).Return battery compartment cover to its proper place, ensuring a triangle is formed on the underside of the controller. Note: battery polarity is marked in the battery compartment Insert the lower end of the battery (2) first, then press on the top end (3) to ensure the battery is firmly in place.Invert the controller and use firm pressure to lift the battery compartment cover (1).
Holding the upper section of the controller above the mechanical handle, use a firm upward twist to release the controller from the skirt.Screw the swivel fitting (3) (not included) of the hydraulic valve onto the filter and use the nipple fitting (5) to connect the other end to the irrigation system. When installing the controller (4) in the irrigation system, a filter (2) (not included) must also be installed between the main irrigation system valve (1) and the controller. Installing the Controller in the Irrigation System Setting Up the Irrigation Controller Note: Before assembling the controller flush the irrigation system Galcon 7001D Computerized Irrigation Controller Parts Identification
#Galcon irrigation timer instructions manual
Galcon 7001D Computerized Irrigation Controller Instruction Manual.
0 kommentar(er)
